Material / process: 

 Lamp housing made of high strength high quality steel, the surface electrostatic spray powder adhesion, uniform and bright, long-winded easily peeled off the shell by welded joints and splicing gap polished smooth, does not look like spray after gap defect; configuration of high purity anodized aluminum reflector, reasonable with light, camp 

 Made of a high degree of illumination environment, to control the degree requirements for certain special occasions; 

 Lamp holder and terminals are made of flame-retardant PC material, in line with the 3C standard; 

 Wire and high temperature of 90 ° C, high voltage 300/500V, in line with the 3C standard; 

 Can be configured to the emergency system, the dimming system. 

 Line with IEC international safety standards, GB7000.1-2002 national standards; 


 Installation / maintenance: 

 Ceiling installation, the suspension system to do the lifting; 

 Hand remove the safety net to the light source replacement, line detection, maintenance; 


 Application / Range: 

 Used in indoor public places in need of protection impact, such as low-ceiling indoor sports venues, the factory area, parking lot.